色哟哟视频在线观看-色哟哟视频在线-色哟哟欧美15最新在线-色哟哟免费在线观看-国产l精品国产亚洲区在线观看-国产l精品国产亚洲区久久

0
  • 聊天消息
  • 系統消息
  • 評論與回復
登錄后你可以
  • 下載海量資料
  • 學習在線課程
  • 觀看技術視頻
  • 寫文章/發帖/加入社區
會員中心
創作中心

完善資料讓更多小伙伴認識你,還能領取20積分哦,立即完善>

3天內不再提示

NE5532音量控制電路,Gain and Volume Adjustment for Balance Input

454398 ? 2018-09-20 19:03 ? 次閱讀

NE5532音量控制電路,Gain and Volume Adjustment for Balance Input

關鍵字:NE5532,音量控制電路圖

The circuit was designed to create a balance input device that would provide an adjustment of gain and volume while having a symmetrical electronic input.NE5532 – an internally compensated low noise dual operational amplifier with features such as full power bandwidth up to 140 KHz, input noise voltage of 8 nV, common mode rejection ratio, 9 V/us slew rate, high DC voltage gain, 32 V peak to peak voltage swing, wide supply voltage range from 3 V to 12 V, unity gain bandwidth at 10 MHz, and internal frequency compensation TL072 – a low noise JFET input operational amplifier with features such as common-mode input voltage range, high slew rate, operation without latch up, compensated internal frequency, high input impedance at the JFET input stage, low noise,low total harmonic distortion, protected from output short circuit, low input bias and offset currents, wide common-mode and differential voltage ranges, and low power consumption The operation of the circuit includes the adjustment of the gain with the use of 10K ohms potentiometer RV1 while the level of the signal or the volume is regulated with the 47K ohms potentiometer RV2. In order to prevent unwanted noises from being absorbed during the regulation of gain, the potentiometer RV1 should be of good quality. Alternatively,the potentiometers can be replaced by other material like a set of resistors that requires enough testing and adjustment to meet the desired output.The integrated circuits used is not necessarily the compulsory to use because other types of models can also be chosen for as long as they possess similar characteristics as what is recommended in this circuit like low noise, low distortion, and other convincing factors. From the values involved in the circuit, the resistance is approximately 2K ohms. This amount is sufficient for low level of signal to be amplified like the one coming from a microphone. An attenuation of signals occurs during the presence of high level signals. In this case, the adjustment of gain with the operation of RV1 is at its boundaries where the resistance decreases for the two input section.


Figure 2
The basic concept of the balance input with gain and volume circuit may be applied in the use of preamplifiers where some advanced designs are coming with remote control that has volume control, input select and mute functions. They are mainly used in home theater systems to provide quality sounds since they are able to adjust the gain and the volume of the output.Source:users.otenet.gr/~athsam/balance_with_gain.htm

聲明:本文內容及配圖由入駐作者撰寫或者入駐合作網站授權轉載。文章觀點僅代表作者本人,不代表電子發燒友網立場。文章及其配圖僅供工程師學習之用,如有內容侵權或者其他違規問題,請聯系本站處理。 舉報投訴
收藏 人收藏

    評論

    相關推薦

    PCM1792有無音量控制,如何通過軟件控制音量

    請教PCM1792有無音量控制,如何通過軟件控制音量
    發表于 11-07 07:51

    pcm1794如何實現音量控制

    設計一個不帶MCU的DAC。選用PCM1794。負載為耳機。請看TPA6120A2的數據手冊,將應用電路中的PCM1792改用PCM1794,從LPF一直到耳機放大器均采用平衡式音頻線路。請教如何實現音量控制,使用4個音量電位
    發表于 11-07 06:17

    請問PCM1794如何實現音量控制

    目前,我們用 PCM1794 + OPA1612 做了一款機頂盒,PCM1794 通過 I2S 和 CPU 連接,通過硬件對 PCM1794 進行配置,板子回來在測試的時候發現無法通過軟件實現音量控制,請問如何實現音量控制,謝謝!
    發表于 10-30 08:33

    使用PCM2706C作為USB轉I2S,無法通過桌面右下角的音量控制欄來控制音量,為什么?

    使用PCM2706C作為USB轉I2S,win7系統驅動正常,播放音樂正常, 但是無法通過桌面右下角的音量控制欄來控制音量,只能通過播放器的音量控制
    發表于 10-17 07:06

    TAS5825音量控制運算位寬是多少,是32bit嗎?

    對于dsp運算控制音量可能會有損音質,大概32bit運算在小音量是會有幾db音質損失。 所以我想知道,TAS5825 音量控制運算位寬是多少,是32bit?TI miniDSP產品中
    發表于 10-11 06:43

    請問TAS5760L怎么通過IIC進行音量控制,需要配置哪些寄存器?

    TAS5760L: 怎么通過IIC進行音量控制,需要配置哪些寄存器
    發表于 09-27 09:36

    使用NE5532做兩級放大,當信號頻率增加到35KHz左右時,兩級放大電路的輸出信號不是正弦波,出現三角波,為什么?

    使用NE5532做兩級放大。發現當信號頻率增加到35KHz左右時,兩級放大電路的輸出信號不是正弦波,出現三角波。NE5532的壓擺率有9v/us,不應該在這么低的頻率下就出現失真。請問這是怎么回事?
    發表于 09-11 08:28

    NE5532 100KHZ方波放大電路,頻率到10多K就嚴重變形了,為什么?

    我按照這個仿真電路搭了實際電路,結果頻率到10多K就嚴重變形了,到100K完全變成了三角波。而仿真結果確是可以實現100K頻率的放大電路。而根據NE5532的數據手冊也應該可以實現
    發表于 09-10 07:09

    NE5532用3.3V供電得不到波形,為什么?

    NE5532用3.3V供電得不到波形
    發表于 08-28 08:20

    NE5532和RC4558做輸入差分,噪音抑制用哪個好?

    NE5532和RC4558做輸入差分,噪音抑制,用哪個好?
    發表于 08-22 06:05

    NE5532NE5532A有什么區別?

    NE5532NE5532A到底有什么區別,手冊翻了2遍沒看出來,麻煩指導下。
    發表于 08-20 08:31

    TL082和NE5532在做音頻前級放大的時候,單電源供電的電源范圍是多少比較合適?

    TL082和NE5532在做音頻前級放大的時候,單電源供電的電源范圍是多少比較合適?在哪個電壓對聲音會比較好?
    發表于 08-13 07:24

    采用NE5532做恒流源,電路在工作時S9013燒毀,怎么解決這個問題

    采用NE5532做恒流源,并用S9013擴流電路如下圖,電路在工作時(電路上電時輸入100mV直流信號,輸出用萬用表短接到地并測量輸出電流)S9013燒毀,根據手冊描述9013的IC
    發表于 08-13 06:25

    es8388的codec在es8388S上音量控制不對頭怎么處理?

    es8388的codec在es8388S上音量控制不對頭。
    發表于 06-28 06:40

    ne5532芯片功能和作用 ne5532工作電壓范圍

    NE5532芯片是一種雙運算放大器芯片,它是由德州儀器公司(Texas Instruments)推出的。NE5532芯片是設計用于高質量音頻放大器和前置放大器電路。它具有低噪聲、低失真和寬帶寬等特點
    的頭像 發表于 01-24 16:49 ?9984次閱讀
    主站蜘蛛池模板: 欧美人妇无码精品久久| 国产亚洲精品精华液| 18禁无遮挡羞羞污污污污免费| 亚洲成年人在线观看| 窝窝午夜色视频国产精品东北| 日韩毛片在线视频| 色屁屁影院| 忘忧草在线影院www日本| 四虎永久在线精品免费A| 特黄特色大片免费播放器9| 三级网站午夜三级| 色青青草原桃花久久综合| 色四房播播| 婷婷开心激情综合五月天| 王雨纯羞羞| 亚洲精品久久久一区| 亚洲色图在线观看视频| 亚洲一级特黄| 中文字幕在线观看亚洲视频| 11 13加污女qq看他下面| 757一本到午夜宫| eussse手机电影在线观看| YELLOW日本动漫免费动漫| 嘟嘟嘟在线视频免费观看高清中文 | free18sex性自拍裸舞| 99免费视频观看| 成人在线观看视频免费| 国产乱码免费卡1卡二卡3卡四卡 | 在线播放一区二区精品产| 1a级毛片免费观看| 啊灬啊灬啊灬快高潮视频| 风月宝鉴之淫乱英雄传 电影| 国产精品久久久久久久人人看| 国产午夜伦伦伦午夜伦| 久久re视频这里精品青| 美女厕所撒尿ass| 日韩亚洲欧美中文高清在线| 息与子在线交尾中文字幕| 一本色道久久综合亚洲精品加| 97SE亚洲国产综合在线| 高h乱np甄宓|