ADI公司的ADMV1013是24GHz至44GHz 寬帶微波升頻器,提供兩種升頻轉換模式:從基帶 I/Q 直接轉換為 RF和從實際 IF 進行單邊帶升頻轉換,LO輸入頻率范圍從5.4GHz至10.25 GHz,可實現高達41GHz的LO四倍頻器,工作溫度?40℃到+85℃,主要用在點對點微波無線電,雷達,電子戰爭系統,儀表和自動測試設備(ATE).而ADMV1013-EVALZ評估板將ADMV1013與微控制器,低壓差(LDO)穩壓器和AD5601 nanoDAC?結合在一起，可以快速輕松地評估ADMV1013.微控制器可以讓用戶通過分析,控制和評估(ACE)軟件配置ADMV1013寄存器映射.LDO 穩壓器支持由單一電源為 ADMV1013 供電,并提供電源紋波抑制功能.AD5601 nanoDAC讓用戶在不使用外部電源的情況下衰減來自ADMV1013的混頻器的射頻(RF)功率.本文介紹了ADMV1013主要特性,功能框圖,以及評估板ADMV1013-EVALZ主要特性,配置圖,實驗室建立圖,電路圖,材料清單和PCB設計圖.

The ADMV1013 is a wideband, microwave upconverter optimized for point to point microwave radio designs operating in the 24 GHz to 44 GHz radio frequency (RF) range.

The upconverter offers two modes of frequency translation. The device is capable of direct conversion to RF from baseband in-phase quadrature (I/Q) input signals, as well as single-sideband (SSB) upconversion from complex intermediate frequency (IF) inputs. The baseband I/Q input path can be disabled and modulated complex IF signals, anywhere from 0.8 GHz to 6.0 GHz, can be inserted in the IF path and upconverted to 24 GHz to 44 GHz while suppressing the unwanted sideband by typically better than 26 dBc. The serial port interface (SPI) allows adjustment of the quadrature phase and mixer gate voltage to allow optimum sideband suppression and local oscillator (LO) nulling. In addition, the SPI interface allows powering down the output envelope detector to reduce power consumption.

The ADMV1013 upconverter comes in a 40-terminal land grid array package (LGA) package. The ADMV1013 operates over the ?40℃ to +85℃ case temperature range.

ADMV1013主要特性:

Wideband RF input frequency range: 24 GHz to 44 GHz
2 upconversion modes
Direct conversion from baseband I/Q to RF
Single-sideband upconversion from real IF
LO input frequency range: 5.4 GHz to 10.25 GHz
LO quadrupler for up to 41 GHz
Matched 50 Ω single-ended RF output and IF inputs
Option between matched 100 Ω balanced or 50 Ω single-ended LO inputs
100 Ω balanced baseband inputs
Sideband suppression and carrier feedthrough optimization
Variable attenuator for transceiver power control
Programmable via 4-wire SPI interface
40-terminal land grid array package (LGA)

ADMV1013應用:

Point to point microwave radios
Radar, electronic warfare systems
Instrumentation, automatic test equipment (ATE)

圖1.ADMV1013功能框圖

評估板ADMV1013-EVALZ

The ADMV1013-EVALZ evaluation board incorporates the ADMV1013 with a microcontroller, low dropout (LDO) regulators, and the AD5601 nanoDAC? to allow the quick and easy evaluation of the ADMV1013. The microcontroller allows the user to configure the ADMV1013 register map through the Analysis, Control, Evaluation (ACE) software. The LDO regulators allow the ADMV1013 to be powered on by a single supply, and offer power supply ripple rejection. The AD5601 nanoDAC allows the user to attenuate the radio frequency (RF) power from the mixer of the ADMV1013 without using an external power supply.

The ADMV1013 is a silicon germanium (SiGe) design, wideband, microwave upconverter optimized for point to point microwave radio designs operating in a frequency range of 24 GHz to 44 GHz.

The ADMV1013 comes in a compact, thermally enhanced, 6 mm × 6 mm LGA package, and operates over a temperature range of ?40℃ to +85℃. For full details on the ADMV1013, see the ADMV1013 data sheet. Consult the data sheet in conjunction with this ADMV1013-EVALZ user guide when using the ADMV1013-EVALZ evaluation board.

評估板ADMV1013-EVALZ主要特性:

Full feature evaluation board for the ADMV1013
On-board USB for SPI control
5 V operation
ACE software interface for SPI control
?

圖2.評估板ADMV1013-EVALZ外形圖

圖3.評估板ADMV1013-EVALZ配置圖

圖4.評估板ADMV1013-EVALZ頂視圖

圖5.評估板ADMV1013-EVALZ I/Q輸入實驗室建立圖

圖6.評估板ADMV1013-EVALZ IF輸入實驗室建立圖

圖7.評估板ADMV1013-EVALZ電路圖:ADMV1013連接

圖8.評估板ADMV1013-EVALZ電路圖:MCU和電平轉換器連接

圖9.評估板ADMV1013-EVALZ電路圖:LDO穩壓器連接
評估板ADMV1013-EVALZ材料清單:

圖10.評估板ADMV1013-EVALZ正面圖

圖11.評估板ADMV1013-EVALZ背面圖

圖12.評估板ADMV1013-EVALZ PCB布局圖:頂層

圖13.評估板ADMV1013-EVALZ PCB布局圖:第二層

圖14.評估板ADMV1013-EVALZ PCB布局圖:第三層

圖15.評估板ADMV1013-EVALZ PCB布局圖:底層