資料介紹
High volume USB 2.0 devices will be designed using ASIC technology with embedded USB 2.0 support.For full-speed USB devices the operating frequency was low enough to allow data recovery to be handled in a vendors VHDL code, with the ASIC vendor providing only a simple level translator to meet the USB signaling requirements. Today's gate arrays operate comfortably between 30 and 60 MHz. With USB 2.0signaling running at hundreds of MHz, the existing design methodology must change.As operating frequencies go up it becomes more difficult to compile VHDL code without modification.This document defines the USB 2.0 Transceiver Macrocell Interface (UTMI) and many operational aspects of the USB 2.0 Transceiver Macrocell (UTM). The intent of the UTMI is to accelerate USB 2.0 peripheral development. This document defines an interface to which ASIC and peripheral vendors can develop.ASIC vendors and foundries will implement the UTM and add it to their device libraries. Peripheral and IP vendors will be able to develop their designs, insulated from the high-speed and analog circuitry issues associated with the USB 2.0 interface, thus minimizing the time and risk of their development cycles.The figure below summarizes a number of concepts expressed throughout this spec. There are assumed to be three major functional blocks in a USB 2.0 peripheral ASIC design: the USB 2.0 Transceiver Macrocell,the Serial Interface Engine (SIE), and the device specific logic.
USB 2.0 Transceiver Macrocell (UTM)
This block handles the low level USB protocol and signaling. This includes features such as; data serialization and deserialization, bit stuffing and clock recovery and synchronization. The primary focus of this block is to shift the clock domain of the data from the USB 2.0 rate to one that is compatible with the general logic in the ASIC.
Some key features of the USB 2.0 Transceiver are:
? Eliminates high speed USB 2.0 logic design for peripheral developers
? Standard Transceiver interface enables multiple IP sources for USB 2.0 SIE VHDL
? Supports 480 Mbit/s "High Speed" (HS)/ 12 Mbit/s “Full Speed” (FS), FS Only and "Low Speed" (LS)
Only 1.5 Mbit/s serial data transmission rates.
? Utilizes 8-bit parallel interface to transmit and receive USB 2.0 cable data
? SYNC/EOP generation and checking
? Allows integration of high speed components in to a single functional block as seen by the peripheral designer
? High Speed and Full Speed operation to support the development of "Dual Mode" devices
? Data and clock recovery from serial stream on the USB
- IP_數據表(I-10):USB2.0 Transceiver for TSMC 28nm HPC+
- IP_數據表(I-9):USB2.0 Transceiver for TSMC 40nm LP
- IP_數據表(I-26):USB2.0 Transceiver for Samsung 28nm
- IP_數據表(I-10):USB2.0 Transceiver for TSMC 28nm HPC+
- IP_數據表(I-9):USB2.0 Transceiver for TSMC 40nm LP
- IP_數據表(I-26):USB2.0 Transceiver for Samsung 28nm
- USB 2.0技術協議英文資料匯總下載 11次下載
- USB 2.0高速4端口集線器控制器MA8601 23次下載
- USB2.0規范 32次下載
- USB 2.0升集線器控制器GL850G規格說明書 0次下載
- MoBL-USBTMTX3LP18 USB2.0 ULPI
- usb driver 2.0下載
- usb 2.0驅動下載xp usb 2.0驅動程序
- USB On-the-Go Transceiver and
- RT2501USB USB1.1/2.0 Wireless
- USB 2.0信號質量測試 146次閱讀
- Diodes公司USB 2.0信號調節器PI5USB212產品介紹 316次閱讀
- USB2.0單/雙接口ESD靜電浪涌保護方案 1758次閱讀
- 基于uPD720100控制器實現新型USB2.0高速主機適配卡的應用方案 2759次閱讀
- usb2.0接口與usb3.0接口有什么區別 2.6w次閱讀
- USB2.0設備接口IP核的設計實用性分析 1691次閱讀
- 基于FPGA NANO2開發板實現USB2.0接口通信的設計方案 3278次閱讀
- USB 2.0和USB 3.0的性能對比分析 6940次閱讀
- USB 2.0和USB 3.0的基本區別對比分析 2.3w次閱讀
- 基于ZU+系列MPSoC芯片的USB3.0/2.0接口硬件設計 6278次閱讀
- USB2.0主機測試方法及控制原理解析 7991次閱讀
- USB 3.0電纜與USB 2.0電纜對比分析 5356次閱讀
- USB 3.2接口的特征, USB 3.0和USB 2.0的區別 8.5w次閱讀
- USB2.0和USB3.0區別是什么詳解! 6w次閱讀
- 精通USB 2.0集線器電源管理 4444次閱讀
下載排行
本周
- 1電子電路原理第七版PDF電子教材免費下載
- 0.00 MB | 1490次下載 | 免費
- 2單片機典型實例介紹
- 18.19 MB | 93次下載 | 1 積分
- 3S7-200PLC編程實例詳細資料
- 1.17 MB | 27次下載 | 1 積分
- 4筆記本電腦主板的元件識別和講解說明
- 4.28 MB | 18次下載 | 4 積分
- 5開關電源原理及各功能電路詳解
- 0.38 MB | 10次下載 | 免費
- 6基于AT89C2051/4051單片機編程器的實驗
- 0.11 MB | 4次下載 | 免費
- 7基于單片機和 SG3525的程控開關電源設計
- 0.23 MB | 3次下載 | 免費
- 8基于單片機的紅外風扇遙控
- 0.23 MB | 3次下載 | 免費
本月
- 1OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234313次下載 | 免費
- 2PADS 9.0 2009最新版 -下載
- 0.00 MB | 66304次下載 | 免費
- 3protel99下載protel99軟件下載(中文版)
- 0.00 MB | 51209次下載 | 免費
- 4LabView 8.0 專業版下載 (3CD完整版)
- 0.00 MB | 51043次下載 | 免費
- 5555集成電路應用800例(新編版)
- 0.00 MB | 33562次下載 | 免費
- 6接口電路圖大全
- 未知 | 30320次下載 | 免費
- 7Multisim 10下載Multisim 10 中文版
- 0.00 MB | 28588次下載 | 免費
- 8開關電源設計實例指南
- 未知 | 21539次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935053次下載 | 免費
- 2protel99se軟件下載(可英文版轉中文版)
- 78.1 MB | 537791次下載 | 免費
- 3MATLAB 7.1 下載 (含軟件介紹)
- 未知 | 420026次下載 | 免費
- 4OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234313次下載 | 免費
- 5Altium DXP2002下載入口
- 未知 | 233046次下載 | 免費
- 6電路仿真軟件multisim 10.0免費下載
- 340992 | 191183次下載 | 免費
- 7十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183277次下載 | 免費
- 8proe5.0野火版下載(中文版免費下載)
- 未知 | 138039次下載 | 免費
評論
查看更多