資料介紹
The SN74LVTH322374 is a 32-bit edge-triggered D-type flip-flop with 3-state outputs designed for low-voltage (3.3-V) VCC operation, but with the capability to provide a TTL interface to a 5-V system environment. It is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
This device can be used as four 8-bit flip-flops, two 16-bit flip-flops, or one 32-bit flip-flop. On the positive transition of the clock (CLK), the Q outputs of the flip-flop take on the logic levels set up at the D inputs.
A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines without need for interface or pullup components.
OE does not affect internal operations of the flip-flop. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
The outputs, which are designed to source or sink up to 12 mA, include equivalent 22- series resistors to reduce overshoot and undershoot.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
When VCC is between 0 and 1.5 V, the devices are in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5 V, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for hot-insertion applications using Ioff and power-up 3-state. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. The power-up 3-state circuitry places the outputs in the high-impedance state during power up and power down, which prevents driver conflict.
- 具有3態輸出的3.3-V ABT 16位緩沖器/驅動器SN54LVTH16541 SN74LVTH16541數據表
- 具有3態輸出的3.3-V ABT 16位緩沖器/驅動器SN54LVTH162541 SN74LVTH162541數據表
- 具有3態輸出的3.3-V ABT 16位緩沖器/驅動器SN74LVTH16244A-EP數據表
- 具有3態輸出的3.3-V ABT 16位總線收發器SN74LVTH16245A-EP數據表
- 具有3態輸出的3.3-V ABT 16位緩沖器/驅動器SN54LVTH16240 SN74LVTH16240數據表
- 具有3態輸出的3.3-V ABT 16位邊緣放大D型觸發器SN54LVTH162374 SN74LVTH162374數據表
- 3.3-V ABT 16位透明D型三態輸出鎖存器SN54LVTH162373 SN74LVTH162373數據表
- 3.3-V ABT 16位透明D型三態輸出鎖存器SN54LVTH16373 SN74LVTH16373 數據表
- 具有3態輸出的3.3伏ABT八路總線收發器SN54LVTH2245 SN74LVTH2245數據表
- 具有3態輸出的3.3-V ABT 16位總線收發器SN74LVTH16245A數據表
- SN74LVTH32373,pdf(3.3-V ABT 32
- SN74LVTH32374,pdf(3.3-V ABT 32
- SN74LVTH32245,pdf(3.3-V ABT 32
- SN74LVTH16245A-Q1,pdf(3.3-V AB
- SN74LVTH32244,pdf93.3-V ABT 32
- 如何將5V輸出安全轉換為3.3V輸入 3291次閱讀
- 3.3V穩壓電源設計 5286次閱讀
- 如何將5V系統的輸出接到3.3V系統的輸入上呢 3256次閱讀
- 基于雙口RAM和SN74LVTH245A芯片實現長距離數據傳輸系統的設計 3802次閱讀
- 3.3轉5V的電平相互轉換電路設計 2.2w次閱讀
- dfrobotDC-DC降壓電源模塊5.5~28V轉3.3V3A介紹 3456次閱讀
- 如何運行自己的ABT鏈節點 889次閱讀
- 淺談SN74HC541特征應用及設備信息 3570次閱讀
- 電源中的+12V/+5V/+3.3V都給哪些硬件供電? 3.9w次閱讀
- 5V轉3.3V如何設計方案? 3990次閱讀
- 12v轉3.3v電路圖大全(五款12v轉3.3v電路原理圖詳解) 8.4w次閱讀
- SN74LS161在數字電路中的抗干擾應用 7065次閱讀
- ch340g電路圖5v和3.3v供電電路 14.3w次閱讀
- 3v和5v雙向電平怎么轉換電路 14.4w次閱讀
- Riverside:3.3V輸入、12V(15V)輸出的隔離電源 3770次閱讀
下載排行
本周
- 1TC358743XBG評估板參考手冊
- 1.36 MB | 330次下載 | 免費
- 2開關電源基礎知識
- 5.73 MB | 11次下載 | 免費
- 3嵌入式linux-聊天程序設計
- 0.60 MB | 3次下載 | 免費
- 4DIY動手組裝LED電子顯示屏
- 0.98 MB | 3次下載 | 免費
- 5基于FPGA的C8051F單片機開發板設計
- 0.70 MB | 2次下載 | 免費
- 651單片機窗簾控制器仿真程序
- 1.93 MB | 2次下載 | 免費
- 751單片機PM2.5檢測系統程序
- 0.83 MB | 2次下載 | 免費
- 8基于51單片機的RGB調色燈程序仿真
- 0.86 MB | 2次下載 | 免費
本月
- 1OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234315次下載 | 免費
- 2555集成電路應用800例(新編版)
- 0.00 MB | 33566次下載 | 免費
- 3接口電路圖大全
- 未知 | 30323次下載 | 免費
- 4開關電源設計實例指南
- 未知 | 21549次下載 | 免費
- 5電氣工程師手冊免費下載(新編第二版pdf電子書)
- 0.00 MB | 15349次下載 | 免費
- 6數字電路基礎pdf(下載)
- 未知 | 13750次下載 | 免費
- 7電子制作實例集錦 下載
- 未知 | 8113次下載 | 免費
- 8《LED驅動電路設計》 溫德爾著
- 0.00 MB | 6656次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935054次下載 | 免費
- 2protel99se軟件下載(可英文版轉中文版)
- 78.1 MB | 537798次下載 | 免費
- 3MATLAB 7.1 下載 (含軟件介紹)
- 未知 | 420027次下載 | 免費
- 4OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234315次下載 | 免費
- 5Altium DXP2002下載入口
- 未知 | 233046次下載 | 免費
- 6電路仿真軟件multisim 10.0免費下載
- 340992 | 191186次下載 | 免費
- 7十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183279次下載 | 免費
- 8proe5.0野火版下載(中文版免費下載)
- 未知 | 138040次下載 | 免費
評論
查看更多