資料介紹
The SN74LVTH32373 is a 32-bit transparent D-type latch designed for low-voltage (3.3-V) VCC operation, but with the capability to provide a TTL interface to a 5-V system environment. This device is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
This device can be used as four 8-bit latches, two 16-bit latches, or one 32-bit latch. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the levels set up at the D inputs.
A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without interface or pullup components.
OE does not affect internal operations of the latch. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
Inputs can be driven from either 3.3-V or 5-V devices. This feature allows the use of these devices as translators in a mixed 3.3-V/5-V system environment.
When VCC is between 0 and 1.5 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5 V, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for hot-insertion applications using Ioff and power-up 3-state. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. The power-up 3-state circuitry places the outputs in the high-impedance state during power up and power down, which prevents driver conflict.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
- 具有3態輸出的3.3-V ABT 16位緩沖器/驅動器SN54LVTH16541 SN74LVTH16541數據表
- 具有3態輸出的3.3-V ABT 16位緩沖器/驅動器SN54LVTH162541 SN74LVTH162541數據表
- 具有3態輸出的3.3-V ABT 16位緩沖器/驅動器SN74LVTH16244A-EP數據表
- 具有3態輸出的3.3-V ABT 16位總線收發器SN74LVTH16245A-EP數據表
- 具有3態輸出的3.3-V ABT 16位緩沖器/驅動器SN54LVTH16240 SN74LVTH16240數據表
- 具有3態輸出的3.3-V ABT 16位邊緣放大D型觸發器SN54LVTH162374 SN74LVTH162374數據表
- 3.3-V ABT 16位透明D型三態輸出鎖存器SN54LVTH162373 SN74LVTH162373數據表
- 3.3-V ABT 16位透明D型三態輸出鎖存器SN54LVTH16373 SN74LVTH16373 數據表
- 具有3態輸出的3.3-V ABT 16位總線收發器SN74LVTH16245A數據表
- SN74LVTH32374,pdf(3.3-V ABT 32
- SN74LVTH322374,pdf(3.3-V ABT 3
- SN74LVTH32245,pdf(3.3-V ABT 32
- SN74LVTH16245A-Q1,pdf(3.3-V AB
- SN74LVTH32244,pdf93.3-V ABT 32
- SN54LVTH540, SN74LVTH540,pdf(3.3-V ABT 16-BIT BUFFERS/DRIVER
- 如何將5V輸出安全轉換為3.3V輸入 3291次閱讀
- 3.3V穩壓電源設計 5286次閱讀
- 9種實用的將3.3V輸出連接到5V輸入的方法! 3382次閱讀
- 如何將5V系統的輸出接到3.3V系統的輸入上呢 3256次閱讀
- 基于雙口RAM和SN74LVTH245A芯片實現長距離數據傳輸系統的設計 3802次閱讀
- 3.3轉5V的電平相互轉換電路設計 2.2w次閱讀
- 如何運行自己的ABT鏈節點 889次閱讀
- 淺談SN74HC541特征應用及設備信息 3570次閱讀
- 分享SN74HC541N集成塊的功能及邏輯圖函數表 1.1w次閱讀
- 電源中的+12V/+5V/+3.3V都給哪些硬件供電? 3.9w次閱讀
- 3.3v穩壓電路電容作用 3.3v穩壓電路典型電路圖及分析 3.9w次閱讀
- 5V轉3.3V如何設計方案? 3990次閱讀
- 12v轉3.3v電路圖大全(五款12v轉3.3v電路原理圖詳解) 8.4w次閱讀
- SN74LS161在數字電路中的抗干擾應用 7065次閱讀
- 隔離式3.3V轉5V轉換器的分立設計 4155次閱讀
下載排行
本周
- 1TC358743XBG評估板參考手冊
- 1.36 MB | 330次下載 | 免費
- 2開關電源基礎知識
- 5.73 MB | 11次下載 | 免費
- 3嵌入式linux-聊天程序設計
- 0.60 MB | 3次下載 | 免費
- 4DIY動手組裝LED電子顯示屏
- 0.98 MB | 3次下載 | 免費
- 5基于FPGA的C8051F單片機開發板設計
- 0.70 MB | 2次下載 | 免費
- 651單片機窗簾控制器仿真程序
- 1.93 MB | 2次下載 | 免費
- 751單片機PM2.5檢測系統程序
- 0.83 MB | 2次下載 | 免費
- 8基于51單片機的RGB調色燈程序仿真
- 0.86 MB | 2次下載 | 免費
本月
- 1OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234315次下載 | 免費
- 2555集成電路應用800例(新編版)
- 0.00 MB | 33566次下載 | 免費
- 3接口電路圖大全
- 未知 | 30323次下載 | 免費
- 4開關電源設計實例指南
- 未知 | 21549次下載 | 免費
- 5電氣工程師手冊免費下載(新編第二版pdf電子書)
- 0.00 MB | 15349次下載 | 免費
- 6數字電路基礎pdf(下載)
- 未知 | 13750次下載 | 免費
- 7電子制作實例集錦 下載
- 未知 | 8113次下載 | 免費
- 8《LED驅動電路設計》 溫德爾著
- 0.00 MB | 6656次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935054次下載 | 免費
- 2protel99se軟件下載(可英文版轉中文版)
- 78.1 MB | 537798次下載 | 免費
- 3MATLAB 7.1 下載 (含軟件介紹)
- 未知 | 420027次下載 | 免費
- 4OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234315次下載 | 免費
- 5Altium DXP2002下載入口
- 未知 | 233046次下載 | 免費
- 6電路仿真軟件multisim 10.0免費下載
- 340992 | 191186次下載 | 免費
- 7十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183279次下載 | 免費
- 8proe5.0野火版下載(中文版免費下載)
- 未知 | 138040次下載 | 免費
評論
查看更多