資料介紹
The TRS3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with
± 15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ± 8-kV ESD (IEC61000-4-2, Contact Discharge)
protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides the
electrical interface between an asynchronous communication controller and the serial-port connector. This
combination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, or
compatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V
supply. In addition, the device includes an always-active noninverting output (ROUT2B), which allows
applications using the ring indicator to transmit data while the device is powered down. The device operates at
data signaling rates up to 250 kbit/s and a maximum of 30-V/ μ s driver output slew rate.
Flexible control options for power management are available when the serial port is inactive. The
auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of
operation, if the device does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is
set low, both drivers and receivers (except ROUT2B) are shut off, and the supply current is reduced to 1 μ A.
Disconnecting the serial port or turning off the peripheral drivers causes the auto-powerdown condition to occur.
Auto-powerdown can be disabled when FORCEON and FORCEOFF are high, and should be done when driving
a serial mouse. With auto-powerdown enabled, the device is activated automatically when a valid signal is
applied to any receiver input. The INVALID output is used to notify the user if an RS-232 signal is present at any
receiver input. INVALID is high (valid data) if any receiver input voltage is greater than 2.7 V or less than – 2.7 V
or has been between – 0.3 V and 0.3 V for less than 30 μ s. INVALID is low (invalid data) if all receiver input
voltages are between – 0.3 V and 0.3 V for more than 30 μ s. Refer to Figure 5 for receiver input levels.
The TRS3243EC is characterized for operation from 0 ° C to 70 ° C. The TRS3243EI is characterized for operation
from – 40 ° C to 85 ° C.
± 15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ± 8-kV ESD (IEC61000-4-2, Contact Discharge)
protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides the
electrical interface between an asynchronous communication controller and the serial-port connector. This
combination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, or
compatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V
supply. In addition, the device includes an always-active noninverting output (ROUT2B), which allows
applications using the ring indicator to transmit data while the device is powered down. The device operates at
data signaling rates up to 250 kbit/s and a maximum of 30-V/ μ s driver output slew rate.
Flexible control options for power management are available when the serial port is inactive. The
auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of
operation, if the device does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is
set low, both drivers and receivers (except ROUT2B) are shut off, and the supply current is reduced to 1 μ A.
Disconnecting the serial port or turning off the peripheral drivers causes the auto-powerdown condition to occur.
Auto-powerdown can be disabled when FORCEON and FORCEOFF are high, and should be done when driving
a serial mouse. With auto-powerdown enabled, the device is activated automatically when a valid signal is
applied to any receiver input. The INVALID output is used to notify the user if an RS-232 signal is present at any
receiver input. INVALID is high (valid data) if any receiver input voltage is greater than 2.7 V or less than – 2.7 V
or has been between – 0.3 V and 0.3 V for less than 30 μ s. INVALID is low (invalid data) if all receiver input
voltages are between – 0.3 V and 0.3 V for more than 30 μ s. Refer to Figure 5 for receiver input levels.
The TRS3243EC is characterized for operation from 0 ° C to 70 ° C. The TRS3243EI is characterized for operation
from – 40 ° C to 85 ° C.
下載該資料的人也在下載
下載該資料的人還在閱讀
更多 >
- TRS3243 3V至5.5V多通道RS-232線路驅動器和接收器數據表
- MAX3222 3-V和5.5-V多通道RS-232線路驅動器和接收器數據表
- TRS3232E-Q1,pdf(3-V to 5.5-V M
- MAX3227E,pdf(3-V to 5.5-V Sing
- MAX3238E,pdf(3-V TO 5.5-V Mult
- MAX3243E,pdf(3-V to 5.5-V Mult
- TRS3227,pdf(3-V to 5.5-V Singl
- TRS3238,pdf(3-V to 5.5-V Multi
- TRSF3243,pdf(3-V to 5.5-V Mult
- TRS3222E,pdf(3-V TO 5.5-V MULT
- TRS3223E,pdf(3-V TO 5.5-V MULT
- TRS3227E,pdf(3-V TO 5.5-V SING
- TRS3237E,pdf(3-V to 5.5-V Mult
- TRS3238E,pdf(3-V TO 5.5-V MULT
- TRSF3238E,pdf(3-V to 5.5-V Mul
- 1.5V/3V/6V逆變器電路圖分析 4107次閱讀
- TIA V16與STEP 7 V5.5控制面板對比 1744次閱讀
- TIA V16與STEP 7 V5.5PID控制面板對比 1784次閱讀
- 3V到9V直流轉換器的電路圖分享 3530次閱讀
- 3V-30V/3A可調穩壓電源電路圖 1.2w次閱讀
- dfrobotDC-DC降壓電源模塊5.5~28V轉3.3V3A介紹 3456次閱讀
- 如何將15V轉換為3V輸出 6307次閱讀
- 天嵌科技E9v3卡片電腦-NXP系列簡介 3670次閱讀
- 天嵌科技E9v3卡片電腦套裝-NXP系列簡介 1612次閱讀
- Technologies實現了e2v新一代圖像傳感器的開發 1103次閱讀
- 5V轉3.3V如何設計方案? 3990次閱讀
- 超小型5.5V DC/DC降壓電源模塊具備真6A性能 8839次閱讀
- 3v和5v雙向電平怎么轉換電路 14.4w次閱讀
- 超基礎的3V-5V電平轉換電路圖設計 1.1w次閱讀
- 3V-5V電平轉換電路圖 4316次閱讀
下載排行
本周
- 1使用單片機實現七人表決器的程序和仿真資料免費下載
- 2.96 MB | 44次下載 | 免費
- 2Keysight B1500A 半導體器件分析儀用戶手冊、說明書 (中文)
- 19.00 MB | 4次下載 | 免費
- 3一種新型高效率的服務器電源系統
- 0.85 MB | 1次下載 | 1 積分
- 4PR735,使用UCC28060的600W交錯式PFC轉換器
- 540.03KB | 1次下載 | 免費
- 5WTS-100(1.1) UWB 信標定位系統 彩頁
- 540.48 KB | 1次下載 | 免費
- 6DV2004S1/ES1/HS1快速充電開發系統
- 2.08MB | 1次下載 | 免費
- 7聯想E46L DAOLL6筆記本電腦圖紙
- 1.10 MB | 1次下載 | 5 積分
- 8MATLAB繪圖合集
- 27.12 MB | 1次下載 | 5 積分
本月
- 1使用單片機實現七人表決器的程序和仿真資料免費下載
- 2.96 MB | 44次下載 | 免費
- 2UC3842/3/4/5電源管理芯片中文手冊
- 1.75 MB | 15次下載 | 免費
- 3DMT0660數字萬用表產品說明書
- 0.70 MB | 13次下載 | 免費
- 4ST7789V2單芯片控制器/驅動器英文手冊
- 3.07 MB | 11次下載 | 1 積分
- 5TPS54202H降壓轉換器評估模塊用戶指南
- 1.02MB | 8次下載 | 免費
- 6STM32F101x8/STM32F101xB手冊
- 1.69 MB | 8次下載 | 1 積分
- 7TPS92682-Q1幀定義和示例
- 891.71KB | 6次下載 | 免費
- 8HY12P65/HY12P66數字萬用表芯片規格書
- 0.69 MB | 6次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935119次下載 | 10 積分
- 2開源硬件-PMP21529.1-4 開關降壓/升壓雙向直流/直流轉換器 PCB layout 設計
- 1.48MB | 420061次下載 | 10 積分
- 3Altium DXP2002下載入口
- 未知 | 233084次下載 | 10 積分
- 4電路仿真軟件multisim 10.0免費下載
- 340992 | 191367次下載 | 10 積分
- 5十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183335次下載 | 10 積分
- 6labview8.5下載
- 未知 | 81581次下載 | 10 積分
- 7Keil工具MDK-Arm免費下載
- 0.02 MB | 73807次下載 | 10 積分
- 8LabVIEW 8.6下載
- 未知 | 65987次下載 | 10 積分
評論
查看更多