資料介紹
The AD8240 LED driver/monitor, in combination with an external transistor, supplies a constant 12 V to drive LED lamps. This allows cost-effective LED lamp monitoring and short-circuit protection. The output is regulated at 12 V when the supply voltage is between 12.5 V and 27 V.
A CMOS compatible, level-dependent, digital input can be used for PWM control of the LED brightness. VO is turned on when the PWM input is high and turned off when the input is low.
The AD8240 is designed to work with a PWM frequency up to 500 Hz, and a typical PWM range from 5% to 95%.
Open LED detection is accomplished by measuring the change in LED lamp current caused by an open LED(s) through the use of an internal high-side current-sense amplifier that amplifies the voltage across an external current shunt. The voltage across the shunt resistor is amplified to a level that can be measured by a microcontroller A/D converter or a comparator. The ability to measure the change in LED lamp current is the key benefit of constant-voltage LED lamp driving.
The output is current-limited by latching off the output voltage when the current reaches a preset level. The current limit is set by selecting the value of the external current shunt that causes the output of the sense amplifier to slightly exceed the 5 V reference level when the current exceeds a maximum level. When the sense amplifier output exceeds 5 V, it trips an internal comparator that causes the driver to latch off the output voltage. The latch is reset during the next PWM cycle. The overcurrent condition can also be detected by a microcontroller or external comparator by measuring the sense amplifier output.
- Arduino/Android藍牙串行監視器應用程序
- 樂化液晶驅動程序下載 7次下載
- STM32的ADC驅動程序
- USB驅動程序
- 多電池監視器LTC6811-1/LTC6811-2數據手冊 47次下載
- 溫度監視器
- AD8240:LED驅動器/監視器數據表
- 定時器延時控制電機驅動程序下載 21次下載
- 使用單片機實現實用熱水器監視器源程序免費下載 13次下載
- 雙向電流功率監視器 8次下載
- AN2534 -實現Microsoft? Windows? 10驅動程序支持的PAC193X集成注意事項 0次下載
- TSC2101觸摸屏,電池,音頻驅動程序的WinCE操作系統 10次下載
- EasyPRO系列通用編程器驅動程序
- AD8240,datasheet,pdf(LED Drive
- acer aspire 5570驅動程序下載
- 怎么編寫Framebuffer驅動程序 402次閱讀
- 如何創建自定義監視器? 516次閱讀
- 光纖應用中的監視器校準 879次閱讀
- 了解和使用無操作系統和平臺驅動程序 1066次閱讀
- 如何通過Raspberry Pi設置CE電流監視器 2120次閱讀
- KUKA C4如何使用診斷監視器? 3591次閱讀
- 米爾科技LINUX設備驅動程序教程 1965次閱讀
- 淺談電腦驅動程序的工作原理 詳解電腦驅動程序意義 2.9w次閱讀
- 8255A驅動程序 3190次閱讀
- 8155驅動程序 3057次閱讀
- 溫濕度傳感器DHT11驅動程序 5.3w次閱讀
- Xilinx設備的驅動程序 7964次閱讀
- 液晶監視器的選購與保養 1022次閱讀
- PCI驅動程序開發實例 6701次閱讀
- 120Hz+全高清LCD監視器新技術應用解析 1335次閱讀
下載排行
本周
- 1TC358743XBG評估板參考手冊
- 1.36 MB | 330次下載 | 免費
- 2開關電源基礎知識
- 5.73 MB | 6次下載 | 免費
- 3100W短波放大電路圖
- 0.05 MB | 4次下載 | 3 積分
- 4嵌入式linux-聊天程序設計
- 0.60 MB | 3次下載 | 免費
- 5基于FPGA的光纖通信系統的設計與實現
- 0.61 MB | 2次下載 | 免費
- 651單片機窗簾控制器仿真程序
- 1.93 MB | 2次下載 | 免費
- 751單片機大棚環境控制器仿真程序
- 1.10 MB | 2次下載 | 免費
- 8基于51單片機的RGB調色燈程序仿真
- 0.86 MB | 2次下載 | 免費
本月
- 1OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234315次下載 | 免費
- 2555集成電路應用800例(新編版)
- 0.00 MB | 33564次下載 | 免費
- 3接口電路圖大全
- 未知 | 30323次下載 | 免費
- 4開關電源設計實例指南
- 未知 | 21549次下載 | 免費
- 5電氣工程師手冊免費下載(新編第二版pdf電子書)
- 0.00 MB | 15349次下載 | 免費
- 6數字電路基礎pdf(下載)
- 未知 | 13750次下載 | 免費
- 7電子制作實例集錦 下載
- 未知 | 8113次下載 | 免費
- 8《LED驅動電路設計》 溫德爾著
- 0.00 MB | 6653次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935054次下載 | 免費
- 2protel99se軟件下載(可英文版轉中文版)
- 78.1 MB | 537796次下載 | 免費
- 3MATLAB 7.1 下載 (含軟件介紹)
- 未知 | 420026次下載 | 免費
- 4OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234315次下載 | 免費
- 5Altium DXP2002下載入口
- 未知 | 233046次下載 | 免費
- 6電路仿真軟件multisim 10.0免費下載
- 340992 | 191185次下載 | 免費
- 7十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183279次下載 | 免費
- 8proe5.0野火版下載(中文版免費下載)
- 未知 | 138040次下載 | 免費
評論
查看更多