資料介紹
In order to complete the interface, there are two additional unique sequences to reset the device and to initiate a nonvolatile write cycle. A RESET condition is recognized by the X84041 whenever the system processor issues the following sequence:"read", "write a zero", and "read". This 3-bus cycle
sequence is used to initialize the part before a read or write sequence or to interrupt a sequence already in progress. An INITIATE NONVOLATILE WRITE
CYCLE condition is recognized by the X84041 whenever the system processor issues the following sequence: "read", "write a one", and "read". This
sequence is used to begin an internal write cycle after data has been loaded into the device. An additional feature of the device is the ability to determine the early completion of an internal nonvolatile write cycle.
This can be accomplished by "polling" the level of the I/O pin during a nonvolatile write cycle. When the I/O pin can be read as a logic HIGH, then the cycle is complete and the part is again able to interact within
the system.
sequence is used to initialize the part before a read or write sequence or to interrupt a sequence already in progress. An INITIATE NONVOLATILE WRITE
CYCLE condition is recognized by the X84041 whenever the system processor issues the following sequence: "read", "write a one", and "read". This
sequence is used to begin an internal write cycle after data has been loaded into the device. An additional feature of the device is the ability to determine the early completion of an internal nonvolatile write cycle.
This can be accomplished by "polling" the level of the I/O pin during a nonvolatile write cycle. When the I/O pin can be read as a logic HIGH, then the cycle is complete and the part is again able to interact within
the system.
下載該資料的人也在下載
下載該資料的人還在閱讀
更多 >
- TUSB2046x 4端口集線器,用于帶可選串行EEPROM接口的通用串行總線數據表
- 8051MCU與SPI串行EEPROM的接口設計 18次下載
- 使用硬件模塊實現8051MCU與SPI串行EEPROM的接口 14次下載
- 單片機串行數據轉換為并行數據的C語言程序和仿真資料免費下載 9次下載
- 單片機并行數據轉換為串行數據的C語言程序和仿真資料免費下載 10次下載
- 單片機并行數據轉換為串行數據的仿真電路圖 12次下載
- 單片機串行數據轉換為并行數據的仿真電路圖免費下載 13次下載
- 基于8051的Proteus仿真-串行數據轉換為并行數據 10次下載
- 基于8051的Proteus仿真-并行數據轉換為串行數據 16次下載
- 串行數據轉換為并行數據 9次下載
- 并行數據轉換為串行數據.hex 0次下載
- 使用X84041 串行EEPROM直接與并行數據總線接口的特
- X84041 MPS EEPROM與NEC 78K微控制器接
- X84041 MPS EEPROM與Motorola 68H
- X84041 EEPROM與8051微控制器接口及其演示代碼
- 單線串行總線承載隔離電源和數據 1220次閱讀
- 如何正確耦合和端接串行數據通道 1600次閱讀
- 淺談串行 EEPROM 的讀/寫應用程序 2229次閱讀
- 如何利用SerDes降低高帶寬數據接口總線的寬度 2453次閱讀
- 基于FPGA的ARM并行總線和端口設計 6311次閱讀
- SRAM存儲器的并行接口和串行接口對比 4398次閱讀
- 如何實現單片機UART串行數據與CAN數據之間相互轉換 2w次閱讀
- usb是串行接口嗎_串行接口和并行接口有什么區別 6.7w次閱讀
- 串口通信與并行通信有什么區別 1.6w次閱讀
- 74ls194串行數據到并行數據的轉換 2.5w次閱讀
- 串行總線是什么?(優點和作用) 2.6w次閱讀
- 并行總線是什么?(并行總線協議介紹) 1.2w次閱讀
- 并行總線有哪些?串行總線有哪些? 8.1w次閱讀
- 串行總線和并行總線的區別 4.1w次閱讀
- 基于FPGA的ARM并行總線設計與仿真分析 7541次閱讀
下載排行
本周
- 1電子電路原理第七版PDF電子教材免費下載
- 0.00 MB | 1491次下載 | 免費
- 2單片機典型實例介紹
- 18.19 MB | 95次下載 | 1 積分
- 3S7-200PLC編程實例詳細資料
- 1.17 MB | 27次下載 | 1 積分
- 4筆記本電腦主板的元件識別和講解說明
- 4.28 MB | 18次下載 | 4 積分
- 5開關電源原理及各功能電路詳解
- 0.38 MB | 11次下載 | 免費
- 6100W短波放大電路圖
- 0.05 MB | 4次下載 | 3 積分
- 7基于單片機和 SG3525的程控開關電源設計
- 0.23 MB | 4次下載 | 免費
- 8基于AT89C2051/4051單片機編程器的實驗
- 0.11 MB | 4次下載 | 免費
本月
- 1OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234313次下載 | 免費
- 2PADS 9.0 2009最新版 -下載
- 0.00 MB | 66304次下載 | 免費
- 3protel99下載protel99軟件下載(中文版)
- 0.00 MB | 51209次下載 | 免費
- 4LabView 8.0 專業版下載 (3CD完整版)
- 0.00 MB | 51043次下載 | 免費
- 5555集成電路應用800例(新編版)
- 0.00 MB | 33562次下載 | 免費
- 6接口電路圖大全
- 未知 | 30320次下載 | 免費
- 7Multisim 10下載Multisim 10 中文版
- 0.00 MB | 28588次下載 | 免費
- 8開關電源設計實例指南
- 未知 | 21539次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935053次下載 | 免費
- 2protel99se軟件下載(可英文版轉中文版)
- 78.1 MB | 537793次下載 | 免費
- 3MATLAB 7.1 下載 (含軟件介紹)
- 未知 | 420026次下載 | 免費
- 4OrCAD10.5下載OrCAD10.5中文版軟件
- 0.00 MB | 234313次下載 | 免費
- 5Altium DXP2002下載入口
- 未知 | 233046次下載 | 免費
- 6電路仿真軟件multisim 10.0免費下載
- 340992 | 191183次下載 | 免費
- 7十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183277次下載 | 免費
- 8proe5.0野火版下載(中文版免費下載)
- 未知 | 138039次下載 | 免費
評論
查看更多