脈寬調制器工作在不同層次的頻率和功耗-Pulse-Width

Abstract: Build a general-purpose pulse-width modulator using three op amps from a quad-op-amp device.

The many applications for pulse-width modulation (PWM) include voltage regulation, power-level control, and fan-speed control. A PWM circuit for such applications (Figure 1) can be implemented with three op amps from a single quad-op-amp chip. The use of op amps allows a wide variety of applications. Low-power op amps can be used in a low-power system, for example, and high-frequency op amps can be used for a high-frequency PWM. The Figure 1 circuit also generates a triangular wave.

Figure 1. This 3-op-amp circuit produces a triangular wave and a variable-pulsewidth output.

The circuit consists of a triangle-wave generator (U1A and U1B) and a comparator (U1C). U1A is configured as an integrator (or de-integrator), and U1B as a comparator with hysteresis. At power-up, the comparator's output voltage is assumed to be zero.

U1A's non-inverting input is biased at VCC/2. A virtual connection between the inverting and non-inverting inputs allows a constant current through R equal to I = VCC/2R, which charges the capacitor C. Thus, the U1A integrator output increases linearly with time. When it reaches 0.75VCC, the comparator output (U1B) changes to its maximum output voltage (VCC). At that point the integrator begins to de-integrate, causing the output voltage to decrease linearly. When it reaches 0.25VCC the comparator output voltage changes to zero, and the cycle repeats. Thus, the integrator output is a triangular wave that swings between the levels of ? VCC and ?VCC.

U1C compares the triangular wave against the dc level VIN. Its output is a square wave, with a duty cycle that varies from 0% to 100% as VIN varies from ? VCC to ? VCC (Figure 2). Frequency is determined by R, C, R1, and R2:

Equation 1.

Figure 2. The Figure 1 circuit produces these PWM and triangular-wave outputs.

The ratio of R2 and R1 affects the operating frequency and the amplitude of the triangular wave. Given that VTH is the triangular wave's maximum voltage and VTL is its minimum voltage, the amplitude swing is:

Equation 2.

The triangular wave's peak-to-peak voltage (the difference in its maximum and minimum voltages) is centered at the VCC/2 bias voltage generated by R3 and R4. The circuit configuration shown allows the PWM to operate on a single supply. Use micropower op amps and larger resistors (R and R1 - R4) for low-power applications, and high-frequency op amps for higher-frequency applications. (The quad op amp shown comes in a single package.)

閱讀全文

30MHz至1300MHz低功耗直接正交調制器

LTC5599的典型應用是直接轉換I / Q調制器，專為低功耗無線應用而設計，可在RF載波上直接調制差分基帶I和Q信號

2020-06-18 08:15:39

脈寬調制信號是如何創建的？

本文將解釋脈寬調制 （PWM）信號是如何創建的，以及說明您聽到的是音頻頻率而非PWM波形的開關頻率。本文將詳細說明輸出PWM波形為什么比輸出線性波形效率高很多，還將說明為什么某些D類放大器要求LC過濾器，而某些則不需要。

2021-06-08 06:56:02

脈寬調制器SG3525在變頻電源中的應用

　　1 引言　　在中小容量變頻電源的設計中，采用自關斷器件的脈寬調制系統比非自關斷器件的相控系統具有更多的優越性。第二代脈寬調制器SG3525 應用于交流電機調速、U PS 電源以及其他需要PWM

2018-10-18 16:54:40

調制器和解調器

解調器完成相反的工作，它們取出調制信號，把它分解成一個信息信號和一個載波信號。解調之后，載波就不再需要了，所以當信息信號被發送導系統中其它的地方以備其它用途時，載波信號就被忽視了。大多數時候調制器和解調器

2017-12-07 14:11:38

調制器和解調器的測試手段和測試方法

無線數字通訊系統，衛星數字通訊系統，數字通訊電臺等都存在調制器和解調器，在研發和測試這些系統時，調制器和解調器的絕對延時也是我們應該關注和應該測試的一個項目。但是，使用什么手段和如何測試調制器和解調器

2019-07-19 06:15:58

調制器輸出端的DAC寄生信號探討

作者：Habeeb Ur Rahman Mohammed德州儀器我最近應一位客戶的特別要求，評估了 TRF3720 全面集成型 IQ 調制器和 PLL/VCO 線性性能。在測量 OIP3 性能時，我

2018-09-19 14:43:36

調制器／解調器簡介

信號攜帶進行傳播。調制過程在發信端，完成調制過程的裝置叫調制器。解調過程是調制的反過程，即把低頻信號從高頻載波上搬移下來的過程。解調過程在收信端，實現解調的裝置叫解調器。調制器和解調器必須由非線性元

2011-11-18 09:43:27

DVB-T調制器與DVB-H調制器的升級與兼容

DVB-T調制器與DVB-H調制器的升級與兼容要使現有的DVB-T調制器升級到DVB-H，我們必須采取如下措施：1、在DVB-T現有的傳輸參數信令（TPS）上面加入有關的DVB-H信令。2、在

2009-07-17 21:36:34

MSP432的PWM實現模式

MSP432中的PWMPWM編程實例PWM基本概念脈沖寬度調制器PWM工作原理PWM產生一個在高電平和低電平之間重復交替的輸出信號，這個信號被稱為PWM信號，也叫脈寬調制波。通過制定所需的時鐘周期和占空比來控制高電平和低電平的持續時間。PWM控制技術·引言PWM（Pulse Width Modulatio

2021-12-13 06:16:09

SPWM正弦脈寬調制介紹

改善法。分類：　分為兩階式和三階式兩種。（“階”指的是PWM式逆變器輸出電壓在一個周期內的電壓電平數）　當階數為3時，把輸出電壓基波半個周期內的脈沖數稱為PWM逆變電路的脈沖數，在三相橋式逆變電路中，此脈沖數就是在基波一個周期內，同一個逆變開關的開通次數，他等于載波頻率與基波頻率（調制波頻率）之比。載

2021-11-15 08:18:34