Safe Use Document for Lithium Polymer Batteries?
General Guidelines and Warnings:
Use specific Lithium Polymer charger only. Do not use a NiMH or NiCd charger - Failure to do so may a cause fire, which may result in personal injury and property damage.
Never charge batteries unattended. When charging LiPo batteries you should always remain in constant observation to monitor the charging process and react to potential problems that may occur.
Some LiPo chargers on the market may have technical deficiencies that may cause it to charge the LiPo batteries incorrectly or at an improper rate. It is your responsibility solely to assure the charger you purchased works properly. Always monitor charging process to assure batteries are being charged properly. Failure to do so may result in fire.
If at any time you witness a battery starting to balloon or swell up, discontinue charging process immediately, disconnect the battery and observe it in a safe place for approximately 15 minutes. This may cause the battery to leak, and the reaction with air may cause the chemicals to ignite, resulting in fire.
Since delayed chemical reaction can occur, it is best to observe the battery as a safety precaution. Battery observation should occur in a safe area outside of any building or vehicle and away from any combustible material.
Wire lead shorts can cause fire! If you accidentally short the wires, the battery must be placed in a safe area for observation for approximately 15 minutes. Additionally, if a short occurs and contact is made with metal (such as rings on your hand), severe injuries may occur due to the conductibility of electric current.
A battery can still ignite even after 10 minutes.
In the event of a crash, you must remove battery for observation and place in a safe open area away from any combustible material for approximately 15 minutes.
If for any reason you need to cut the terminal wires, it will be necessary to cut each wire separately, ensuring the wires to not touch each other or a short may occur, potentially causing a fire.
To solder a connector: Remove insulating tape of Red wire and solder to positive terminal of a connector, then remove insulating tape of Black wire and solder to the negative terminal of connector. Be careful not to short the wire lead. If you accidentally cause the battery to short, place it in a safe open space and observe the battery for approximately 15 minutes. A battery may swell or even possibly catch fire after a short time.
Never store or charge battery pack inside your car in extreme temperatures, since extreme temperature could ignite fire.
鋰聚合體電池安全的使用指導書
指導方針上將和警告：
只使用特定的鋰聚合體休整器。不要使用 NiMH 或者 NiCd 休整器－失敗做可能造成個人的傷害和財產損害的因素火也可能。
不要要價電池?zé)o隨員的。當要價 LiPo 電池你應該總是留在持續的觀察檢測要價程序而且產生反應可能發生的潛在的問題。
在市場上的一些 LiPo 休整器可能有可能導致它不正確地或在不合適的比率要價 LiPo 電池的技術上的缺乏。它獨自地是你的職責保證你適當?shù)刭?gòu)買了作品的休整器。總是檢測要價程序保證電池被適當?shù)厥召M(fèi)。失敗做因此可能造成火。
如果隨時你目擊開始的一個電池猛漲或者腫起來，停止立刻要價程序，在一個安全的地方分離電池而且觀察它因?yàn)榇蠹s 15 分鐘。這可能導致電池泄漏，而且反應用空氣可能導致化學藥品點燃，造成火。
因?yàn)檠舆t了化學的反應能發生，觀察電池為安全預防最好。電池觀察應該在任何建筑物或車輛的外面和遠離任何易燃的材料在一個安全的區域發生。
電線領引男短褲能引起火！如果你偶然短電線，電池為觀察一定被放在之內一個安全的區域因?yàn)榇蠹s 15 分鐘。此外，如果短發生，而且連絡與金屬 （像是戒指在你的手上）一起做，嚴重的傷害由于電流的傳導性可能發生。
一個電池仍然甚至在 10 分鐘之后能點燃。
結果一個墜毀，你一定為觀察除去電池和一個安全的開著區域的地方遠離任何易燃的材料因?yàn)榇蠹s 15 分鐘。
如果為任何理由你需要減少終點的電線，分開地減少每電線將會是必需的，確定電線不碰彼此或者短可能發生，可能地引起火。
施以焊接一個聯編者：距離使紅色電線和一個聯編者的積極終端機方面的焊接劑的音帶絕緣，當時距離使黑色電線和聯編者的否定終端機方面的焊接劑的音帶絕緣。很小心不對短電線領引。如果你偶然地對短導致電池，把它放在安全的開著空間而且觀察電池因?yàn)榇蠹s 15 分鐘。一個電池可能增大或者甚至可能捕捉在短時間之后的火。
從不商店或費用電池在極端溫度中包裝進你的汽車，因?yàn)闃O端溫度會點燃火。
?